[Spce-user] subscriber number cannot start with 0

[Daniel Grotti]

Yes, you need to run ngcpcfg apply.
You won't drop any established calls cause your are not going to restart
mediaproxy.

Daniel




On 08/08/2013 03:05 PM, Theo wrote:
> Hi Daniel
> 
> Thanks for the super fast response. Will I need to do ngcpcfg apply
> 
> If so, I have never been sure on that one - will it drop calls if apply
> that? In which case I will do it after hours, but we don't really ever
> have an after hours :-)
> 
> Cheers
> 
> 
> On Thu, Aug 8, 2013 at 2:56 PM, Daniel Grotti <dgrotti at sipwise.com
> <mailto:dgrotti at sipwise.com>> wrote:
> 
>     Hi,
>     you need to change it in /etc/ngcp-config/config.yml :
> 
>     routing:
>           ac_regex: '[1-9]\d{0,4}'
>           cc_regex: '[1-9]\d{0,3}'
>           sn_regex: '[1-9]\d+'
> 
> 
>     Daniel
> 
> 
>     On 08/08/2013 02:49 PM, Theo wrote:
>     > Hi
>     >
>     > I am trying to allocate numbers to subscribers. Their subscriber
>     number
>     > however starts with a 0 which is not accepted by sipwise - it says
>     > numbers starting with a 0 are not allowed.......
>     >
>     > Where would we change this?
>     >
>     >
>     > _______________________________________________
>     > Spce-user mailing list
>     > Spce-user at lists.sipwise.com <mailto:Spce-user at lists.sipwise.com>
>     > http://lists.sipwise.com/listinfo/spce-user
>     >
> 
>     _______________________________________________
>     Spce-user mailing list
>     Spce-user at lists.sipwise.com <mailto:Spce-user at lists.sipwise.com>
>     http://lists.sipwise.com/listinfo/spce-user
> 
>