[Spce-user] Special characters in subscriber peer_auth_user

[Rogier Banis]

I am using version 2.8 so i will re-install with v3.0 and try again. Thank you all.



Op 27 sep. 2013, om 11:29 heeft Daniel Grotti <dgrotti at sipwise.com> het volgende geschreven:

> Hi Rogier,
> 
> which version are you using ?
> Cause I can set a peer_auth_user like "123*11" in subscriber->Remote
> Authtentication->peer_auth_user on SPCE 3.0.
> 
> 
> Daniel
> 
> 
> 
> On 09/27/2013 11:18 AM, Rogier Banis wrote:
>> Anyone has an idea about this?
>> 
>> Thanks!
>> 
>> 
>> Op 27 sep. 2013, om 01:08 heeft Rogier Banis <rogier at ningaloo.nl
>> <mailto:rogier at ningaloo.nl>> het volgende geschreven:
>> 
>>> Hi all,
>>> 
>>> I am new in using SPCE but have it up and running now. I am going to
>>> use it mainly as SBC-B2BUA. Now setting this up i am running into a
>>> problem with the peer_auth_user name. Our PBX works with sip usernames
>>> like 0000*00 so for me it is mandatory that i can define and use a *
>>> in the username. The GUI of SPCE does not allow me to use this *
>>> character. Does anyone have a suggestion in how to overcome this issue?
>>> 
>>> Thank you very much in advance..
>>> 
>>> With best regards,
>>> Rogier
>> 
>> 
>> 
>> _______________________________________________
>> Spce-user mailing list
>> Spce-user at lists.sipwise.com
>> http://lists.sipwise.com/listinfo/spce-user
>> 
> 
> _______________________________________________
> Spce-user mailing list
> Spce-user at lists.sipwise.com
> http://lists.sipwise.com/listinfo/spce-user

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sipwise.com/pipermail/spce-user_lists.sipwise.com/attachments/20130927/a473d9f2/attachment-0001.html>