[Spce-user] Spce set up question!

[Andrew Pogrebennyk]

Hello,

it takes sometimes several days to reply, moreover "400 Bad Request: SSL
certificate error" doesn't pop up here very often.
The admin login URL is https://<ip>:1443/login/admin, I don't know what
could have caused the 400 error, try restarting nginx and ngcp-panel.

The networking section in config.yml is not used any more. For SIP and
RTP however, you need to set advertised IP to your elastic IP:
ngcp-network --set-interface=eth0 --advertised-ip=x.y.z.w
ngcpcfg apply

For webrtc, you need to enable ICE in domain preference use_rtpproxy
(select there "with rtpproxy as only" or "as extra ICE candidate".
That's it, use WS URI: ws://<YOUR_IP>:5060/ws or
wss://<YOUR_IP>:1443/wss/sip as your entry point.

Note: this works for browser-to-browser calls, but if you have a mixed
environment you should also enable transcoding. E.g., I would set for
every new webrtc user we need to set those preferences:
srtp_transcoding: Prefer SRTP
rtcp_feedback: Prefer AVPF

And then set defaults for all (non-webrtc) users in the domain:
srtp_transcoding: Force RTP
rtcp_feedback: Force AVP
Also you the same settings as in domain for PSTN termination.

Regards,
Andrew

On 08/04/14 20:21, Alfonso Lopez wrote:
> Sorry if this is spam! I thought I sent this but I don't see any reply. My apologies, I just joined the list so I wasn't sure if it worked the first time or not!
> 
> I was wondering if there was a tutorial or anything for setting up sipwise CE on amazon ec2? I am working on a school project and need a easy to set up public server, which is why I chose sipwise!
> 
> I am having a couple of issues. When I follow the handbook, I get to the part where I need to login to the web console. If I just type in the public IP onto my web browser, I get to the "Self-Administration Login" website. However, when I try the default username and password (administrator), I get "Login failed - Please verify username and password".
> 
> If I try https://<ip>:1443, I get a pop up to accept the certificate. I hit ok, but then I immediately get 400 Bad Request: SSL certificate error.
> 
> I noticed after the install (which I didn't get any major failures for), the /etc/ngcp-config/config.yml did not contain "networking". I added the following to it based on another mailing list I came across:
> 
> networking:
>    iaddress: 127.0.0.1
>    aaddress: <Public IP address given by amazon ec2>
>    eaddress: <ip address for eth0 given by "ip a" command
> 
> Any help would be appreciated!! Thank you so much 
> 
> Instance Information:
> Debian Squeeze 7.4 64 Bit
> Type: t1.micro
> sipwise mr 3.2.1
> 
> 
> Finally, if I want to use webrtc, do I need to configure anything in particular?
> 
> Thanks!
> 
> Greenkirby21
> Sent from my iPhone