[Spce-user] Outgoing Call - Problem

[Jorge Fresneda - Ibersontel]

Hi Daniel,

The problem is not with the CLI, it is with the @ your-domain. For example:


Sipwise Address: 120.23.1.1
Address PBX (subscriber): 192.168.1.2

When I launch a call from the field is as follows:

from: <sip:91111111 at 192.168.1.2>
to: <sip: 922222222@<carrier_ip>


The from should be <sip:91111111 at 120.23.1.1> for the carrier to accept 
calls.


Thanks
Regards,
Jorge



El 07/07/2014 10:12, Daniel Grotti escribió:
> Hi,
> could this be the issue ?
>
>
>  From the habndbook:
>
>     
> If you do NOT authenticate against a peer host, then the caller CLI is
> put into the From and P-Asserted-Identity headers, e.g. "+4312345"
> <sip:+4312345 at your-domain.com>. If you DO authenticate, then the From
> header is "+4312345" <sip:your_peer_auth_user at your_peer_auth_realm> and
> the P-Asserted-Identity header is as usual like
> <sip:+4312345 at your-domain.com>. So for presenting the correct CLI in
> CLIP no screening scenarios, your peering provider needs to extract the
> correct user either from the From Display-Name or from the
> P-Asserted-Identity URI-User.
>
>
>
> Otherwise please give us more information about your peer configuration
> and the call scenario.
>
> Daniel
>
>
>
> On 07/07/2014 10:04 AM, Jorge Fresneda - Ibersontel wrote:
>> Hello,
>>
>> I have a problem in version 2.8 with outgoing calls. In the from
>> field  goes "source@ <pbx_ip>"  instead of  "source@ <sipwise_ip>".
>>
>> What may be because this problem?
>>
>> Thank you very much.
>> Regards
>> Jorge
>>
>> _______________________________________________
>> Spce-user mailing list
>> Spce-user at lists.sipwise.com
>> http://lists.sipwise.com/listinfo/spce-user
>
> _______________________________________________
> Spce-user mailing list
> Spce-user at lists.sipwise.com
> http://lists.sipwise.com/listinfo/spce-user