[Spce-user] SPCE 3.4.2 Peer Registration Question

[Andrew Pogrebennyk]

Hi,
please follow the explanation from
https://www.sipwise.com/doc/mr3.4.2/spce/ar01s06.html#_authenticating_and_registering_against_peering_servers
(scroll a little bit up from this link).

Please always keep the list address in the cc.
Regards.
Andrew

On 14/10/14 15:29, Tom Foley wrote:
> To follow up I guess my real question is this. If I have two peers with
> identical rates to a given endpoint, what is the tie-breaker mechanism?
> As you've likely guessed, I'm new to SPCE and am still acclimatising to
> it's design principles.
> Thanks for your help.
> 
> 
> On Tue, Oct 14, 2014 at 2:26 PM, Tom Foley <tom at tomfoley.net
> <mailto:tom at tomfoley.net>> wrote:
> 
>     Hi Andrew,
> 
>     You're right of course, and thank you for clarifying. I had
>     misunderstood weight was being used as a means for prioritizing
>     outbound routes. Thank you.
> 
>     Tom Foley
> 
> 
>     On Tue, Oct 14, 2014 at 1:49 PM, Andrew Pogrebennyk
>     <apogrebennyk at sipwise.com <mailto:apogrebennyk at sipwise.com>> wrote:
> 
>         Hi Tom,
> 
>         what do you mean by the route weight? The outbound registrations
>         are not
>         passing through the proxy and thus are not using the routing
>         capabilities of your SPCE. The registration is routed by
>         resolving the
>         peer realm that you specify as domain in reg_agent.conf.
> 
>         Andrew
> 
>         On 14/10/14 00:32, Tom Foley wrote:
>         > Firstly let me point out a minor error in the documentation.
>         Section
>         > 6.5.3.2 states the following:
>         >
>         > Configure your peering servers with the corresponding
>         credentials in
>         > /etc/ngcp-config/templates/etc/sems/etc/reg_agent.conf.tt2,
>         then execute
>         > ngcpcfg apply.
>         >
>         > The actual path
>         > is /etc/ngcp-config/templates/etc/ngcp-sems/etc/reg_agent.conf.tt2
>         >
>         > In the template file it is straightforward to add the peer
>         using the
>         > examples provided as comments, but I don't see a parameter for
>         the route
>         > weight. Where would I define that? It doesn't seem to pick it
>         up from
>         > the web interface value (yet).
>         >
>         > Thank you,
>         >
>         > -- Tom
>         >
>         >
> 
> 
>