[Spce-user] Outgoing caller id problem
dgrotti at sipwise.com
Mon Jan 26 07:38:31 EST 2015
can you share the log ?
On 01/26/2015 01:34 PM, Tóth Csaba wrote:
> Dear Daniel,
> We figured out the good number goes to the From field, and the network
> provided number (the default number we want to send out when wrong cli
> we got from user) goes to the PAI field.
> So we setted the outbound_pai_user to None (and the outbound_ppi_user to
> None too), than we captured the invite what the system sended out to the
> gateway service provider, and it still contained the PAI field with the
> network provided number.
> We tried to set the outbound_pai_user to the "UPRN (if set) or
> User-provided-number", but it still sended out the
> network-provided-number as the PAI field.
> How can i set this?
> 2015.01.26. 12:34 keltezéssel, Daniel Grotti írta:
>> please run:
>> ngcp-kamctl proxy fifo debug 2
>> then make the call again and then check /var/log/ngcp/kamailio-proxy.log
>> It could be that the CLI is not matching the allowed_clis, for a rewrite
>> rules issue, or because you are fetching the CLI from the wrong SIP
>> header field.
>> On 01/26/2015 12:26 PM, Tóth Csaba wrote:
>>> i have a subscriber with several clis. It is a Yeastar pbx.
>>> e164_to_ruri is enabled, and the remote party sends the cli as
>>> 361577XXXX. It is in the allowed_clis of course, but it is still sends
>>> out the number setted in the cli field.
>>> I use 3.7.1, what i didn't setted up? How can i debug this?
>>> Thanks in advance!
>>> Spce-user mailing list
>>> Spce-user at lists.sipwise.com
>> Spce-user mailing list
>> Spce-user at lists.sipwise.com
> Spce-user mailing list
> Spce-user at lists.sipwise.com
More information about the Spce-user