[Spce-user] New Community Install

[Henry L. Jones]

Hi Michael,

Thanks for your response.


I am running VMWare ESXi 6.0.0 on a Dell PowerEdge R710 server.  The new VM
for SIPWise was defined as 2 cpus with 2
cores,  2 gb memory, 2 NIC cards, Debian x64 with 60gb hard drive.  The
drive was defined new and not initialized.  The ISO was installed on a
fresh VM. I used the LSI Logic Parallel SCSI controller for the virtual
disk.

Thanks

On Wed, Nov 4, 2015 at 8:22 AM, Michael Prokop <mprokop at sipwise.com> wrote:

> * Henry L. Jones [Tue Nov 03, 2015 at 12:22:25PM -0500]:
>
> > Is anyone having issues when installing SipWise from the iso?  I have
> tried
> > versions 4.1.1 and 3.8.3.  In both instances the installation completes
> > successfully and the system reboots.  After the reboot the system
> reports a
> > grub error.
>
> > Error: fd0 read error
> > Error: no such disk
> > Entering rescue mode ...
> > grub rescue>
>
> > When I enter a set I get:
>
> > prefix=(ngcp-root)/boot/grub
> > root=ngcp-root
>
> > When I enter ls I get:
>
> > (hd0) (fd0)
>
> You should also see (hd0,msdos1) + (ngcp-root).
>
> > I am installing on a VM environment with a definition of 2 cpus with 2
> > cores,  2 gb memory, 2 NIC cards, Debian x64 with 60gb hard drive.
>
> What virtual environment is that? And what type of disks/controller
> is in use for the hard drive? Was there something else installed
> previously on those disks?
>
> regards,
> -mika-
>
> _______________________________________________
> Spce-user mailing list
> Spce-user at lists.sipwise.com
> https://lists.sipwise.com/listinfo/spce-user
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sipwise.com/pipermail/spce-user_lists.sipwise.com/attachments/20151104/7174f807/attachment-0001.html>