[Spce-user] New Community Install
ms at pluteus.at
Wed Nov 4 09:58:55 EST 2015
An HTML attachment was scrubbed...
-------------- next part --------------
, 2 gb memory, is not enough. Think at least 3
Von meinem Windows Phone gesendet
Von: Henry L. Jones
Gesendet: 04.11.2015 15:53
An: spce-user at lists.sipwise.com
Betreff: Re: [Spce-user] New Community Install
Thanks for your response.
I am running VMWare ESXi 6.0.0 on a Dell PowerEdge R710 server. The new VM
for SIPWise was defined as 2 cpus with 2
cores, 2 gb memory, 2 NIC cards, Debian x64 with 60gb hard drive. The
drive was defined new and not initialized. The ISO was installed on a
fresh VM. I used the LSI Logic Parallel SCSI controller for the virtual
On Wed, Nov 4, 2015 at 8:22 AM, Michael Prokop <mprokop at sipwise.com> wrote:
> * Henry L. Jones [Tue Nov 03, 2015 at 12:22:25PM -0500]:
> > Is anyone having issues when installing SipWise from the iso? I have
> > versions 4.1.1 and 3.8.3. In both instances the installation completes
> > successfully and the system reboots. After the reboot the system
> reports a
> > grub error.
> > Error: fd0 read error
> > Error: no such disk
> > Entering rescue mode ...
> > grub rescue>
> > When I enter a set I get:
> > prefix=(ngcp-root)/boot/grub
> > root=ngcp-root
> > When I enter ls I get:
> > (hd0) (fd0)
> You should also see (hd0,msdos1) + (ngcp-root).
> > I am installing on a VM environment with a definition of 2 cpus with 2
> > cores, 2 gb memory, 2 NIC cards, Debian x64 with 60gb hard drive.
> What virtual environment is that? And what type of disks/controller
> is in use for the hard drive? Was there something else installed
> previously on those disks?
> Spce-user mailing list
> Spce-user at lists.sipwise.com
More information about the Spce-user