[Spce-user] Implement rtcp statistics reporting towards Homer in rtpengine in 4.4.1

[Matthias Hohl]

Hello,

thank you i will try that now.

I go back to the file and found out, that after doing a "ngcpcfg apply" command, my prior added parameters are deleted from /etc/default/ngcp-rtpengine-daemon
Is there any other place where I must add this?

Thank you


-----Ursprüngliche Nachricht-----
Von: Spce-user [mailto:spce-user-bounces at lists.sipwise.com] Im Auftrag von Richard Fuchs
Gesendet: Sonntag, 26. Juni 2016 23:49
An: spce-user at lists.sipwise.com
Betreff: Re: [Spce-user] Implement rtcp statistics reporting towards Homer in rtpengine in 4.4.1

On 26/06/16 05:47 PM, Matthias Hohl wrote:
> Hello,
>
> as seen in your changelog this topic should be fixed (MT#18599)
>
> I tried it today and add following parameters here:
> /etc/default/ngcp-rtpengine-daemon
>
> HOMER=homer.telematica.at:5060
>
> HOMER_PROTOCOL=udp
>
> HOMER_ID=999
>
> After that I did a “ngcpcfg apply”
>
> But if I look into homer, I cant see any rtcp statistics.
>
> Is there somewhere else anything to enable to get the statistics out 
> from rtpengine to homer?

Try with an IP address instead of a host name. DNS resolution is not supported.

Cheers
_______________________________________________
Spce-user mailing list
Spce-user at lists.sipwise.com
https://lists.sipwise.com/listinfo/spce-user