[Spce-user] Cisco SPA112 Configuration for SipWise

[Paul Smith]

Dear All,

 
My apologies if this subject has already been covered, but I wondered if someone could point me in the right direction for a working configuration on the Cisco SPA112?

 
I can place outbound calls fine, but inbound are a no-go. I suspect this is because the SPA112 is registering with its internal IP address rather than that of the WAN connection. I have enabled NAT mapping and keep alive but this hasn't made a difference.

 
Any help would be greatly appreciated.

 
Thank you,

 
Paul.

 
--

Paul R. Smith B.Sc. (Hons.)

Managing Director

Data Network Consultants Limited

 
T:   01207 750 550

W: www.daneco.co.uk <http://www.daneco.co.uk> 

 

 
iNorthumberland's Fixed Wireless Access Partner - Superfast Wireless Network Specialists.

 
DANECO is a trading name of Data Network Consultants Limited.

 
Company Reg. No: 06769055
Registered in England and Wales.

 
This email and its contents are confidential and intended for the addressee only. It may not be disclosed to or used by anyone else nor may it be copied in any way. Data Network Consultants Limited nor the sender accepts any responsibility for viruses and it is the addressee's responsibility to check attachments if any. Any opinions expressed in this email are those of the sender and not necessarily those of Data Network Consultants Limited. If received in error please contact the sender to advise then delete from your system.

 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sipwise.com/mailman/private/spce-user_lists.sipwise.com/attachments/20160908/6d8f714a/attachment.html>