[Spce-user] Understanding extra_sockets format in config.yml

Joel Smith | VOZELIA joel at vozelia.com
Thu Nov 8 08:25:52 EST 2012


Thanks Andrew!

The hack was just for testing purposes, I'm undoing it right away :-)

I'll get back to you if anything fails...

Regards,
--
Joel Smith
Cell: +34 639 03 13 53
E-Mail: joel at vozelia.com




On Thu, Nov 8, 2012 at 1:55 PM, Andrew Pogrebennyk
<apogrebennyk at sipwise.com> wrote:
> Joel,
> the correct format consists of a label and value like this:
>     extra_sockets:
>       test: udp:10.15.20.108:6060
> The label is shown in outbound_socket peer preference (you can route
> calls to specific peer out via specific socket).
> I would not recommend to hack this using customtt because in that case
> sip routing will be probably broken.
>
> On 11/08/2012 01:49 PM, Joel Smith | VOZELIA wrote:
>> Hi everybody,
>>
>> I have a system with multiple IP addresses. What is the correct format
>> of the "extra_sockets" parameter inside config.yml?
>>
>> I've tried several different combinations and none make kamailio-lb
>> listen on the secondary ips, so, to solve this I've created a custom
>> tt2 for kamailio-lb but I still need to know what is the correct way
>> to setup extra_sockets in config.yml (otherwise I'll end up with
>> incorrect headers inside sip packets caused by using the wrong IP.)
>>
>> Thanks in advanced.
>>
>> Best regards.
>> --
>> Joel Smith
>> Cell: +34 639 03 13 53
>> E-Mail: joel at vozelia.com
>>
>> _______________________________________________
>> Spce-user mailing list
>> Spce-user at lists.sipwise.com
>> http://lists.sipwise.com/listinfo/spce-user
>>
>




More information about the Spce-user mailing list