[Spce-user] Understanding extra_sockets format in config.yml

Andrew Pogrebennyk apogrebennyk at sipwise.com
Thu Nov 8 07:55:25 EST 2012

the correct format consists of a label and value like this:
      test: udp:
The label is shown in outbound_socket peer preference (you can route
calls to specific peer out via specific socket).
I would not recommend to hack this using customtt because in that case
sip routing will be probably broken.

On 11/08/2012 01:49 PM, Joel Smith | VOZELIA wrote:
> Hi everybody,
> I have a system with multiple IP addresses. What is the correct format
> of the "extra_sockets" parameter inside config.yml?
> I've tried several different combinations and none make kamailio-lb
> listen on the secondary ips, so, to solve this I've created a custom
> tt2 for kamailio-lb but I still need to know what is the correct way
> to setup extra_sockets in config.yml (otherwise I'll end up with
> incorrect headers inside sip packets caused by using the wrong IP.)
> Thanks in advanced.
> Best regards.
> --
> Joel Smith
> Cell: +34 639 03 13 53
> E-Mail: joel at vozelia.com
> _______________________________________________
> Spce-user mailing list
> Spce-user at lists.sipwise.com
> http://lists.sipwise.com/listinfo/spce-user

More information about the Spce-user mailing list