[Spce-user] CallerID

[Joan Cifre (ibred)]

Hi all,
I've checked logs and I think that my PBX (Atcom asterisk based) is not 
sending the Outbound CLI properly to ngcp. It sends always the Fromuser 
parameter, not the Outbound Caller id that can be configured per user. 
So I think this is a bug of my PBX.
Thanks,
Joan

El 30/10/2012 12:33, Jon Bonilla (Manwe) escribió:
> El Tue, 30 Oct 2012 11:45:41 +0100
> "Joan Cifre (ibred)" <jcifre at ib-red.com> escribió:
>
>> Hi Jon,
>> as discussed in previous mails, I have a PBX connected to NGCP as if it
>> was a single user. The PBX authenticates with NGCP as an user. But each
>> IP phine in the PBX send its own CLI, but this is not working. The
>> "trunk" has the possibility of chang the Fromuser, and I've seen that
>> NGCP is using this prameter as CLI, but not the CLI configured in each
>> individual user behind the PBX.
>> The user in NGCP has allowed_cli = * (all)
>> Regards,
>> Joan
>>
>
> Hi Joan.
>
> Does the asterisk pbx send a different "from" for each call? If so, could you
> check the proxy logs and see what cli is taken and if it's validates by the
> provider?
>
> And later on, we should check what callerid parameters are sent ot the end
> usbcriber or sip peer. You need to check what comes out form asterisk, what the
> provider takes and what it sends.
>
> step by step. You can send us traces and logs if you need help.
>
>