[Spce-user] Subscriber with only IP authentication

[Tabi Tabe Tabi]

Thanks Barry.

I will give it a short and feedback to the group.

Regards,

Tabi


On Wed, Apr 30, 2014 at 11:46 AM, Barry Flanagan <barry at flanagan.ie> wrote:

> On 30 April 2014 10:29, Tabi Tabe Tabi <tabi.tabe at gmail.com> wrote:
>
>> Hi,
>>
>> I read in one of the emails that it is possible to setup a subscriber to
>> connect to SPCE with IP address authentication, instead of SIP username and
>> password. I am trying to do that but realized that the subscriber account
>> requires SIP username and password.
>>
>
> It is required to enter one, but it does not have to be used if you set
> Trusted Source and a Permanent Registration.
>
>>
>> I have setup a subscriber with a DID and tested with a polycom phone and
>> it can make outboud and receive inbound calls no problem. On the same
>> account, tried using on an IP PBX which only support IP authentication SIP
>> trunk without SIP username and password and it fails. It can neither
>> receive nor make calls. Here is what I did:
>>
>> Subscriber--->Details --> Preferences --->Trusted Source . Here I added
>> the IP address of the IP PBX (both are in the same LAN and Subnet)
>>
>>
> I presume you also included the Protocol and a From Pattern such as
> "^sip:.*"
>
> If the Trusted source was set up correctly, you should have been able to
> at least make outbound calls from your PBX. If not you need to provide some
> logs.
>
>
>> Then I enabled E164_to_RURI here:
>> Subscriber--->Details --> Preferences --->Number Manipulation
>>
>> By making the changes above, I assume that SPCE will not expect the PBX
>> to send username and password and will process the calls. Also, all calls
>> made to the DID will be routed to the PBX.
>>
>>
> The above will only make it so that SPCE does not require authentication
> when the PBX makes an outbound call. To get inbound working you need also
> to create a Permanent Registration for this peer - this tells SPCE where to
> send calls for this subscriber without the subscriber needing to register
> itself.
>
> Go to
>
> Subscriber---> Details --> Registered Devices -> Create Permanent
> Registration
>
> and enter in something like:
>
> sip:username at ip_address:5060
>
> Where username can be anything (but we would usually keep it the same as
> the subscriber username) and the IP address the IP of the PBX.
>
>
>
>> I have the PBX working fine with Gendband S3 as a reference. Am I doing
>> something wrong or did I miss a step?
>>
>> You feedback is much appreciated.
>>
>
> Hope this helps.
>
> -Barry
>
>
>>
>> Regards,
>>
>>
>> --
>> ...Tabi
>>
>>
>> _______________________________________________
>> Spce-user mailing list
>> Spce-user at lists.sipwise.com
>> http://lists.sipwise.com/listinfo/spce-user
>>
>>
>


-- 
...Tabi
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sipwise.com/pipermail/spce-user_lists.sipwise.com/attachments/20140430/a267a16e/attachment-0001.html>