[Spce-user] Subscriber with only IP authentication

[Barry Flanagan]

On 30 April 2014 10:29, Tabi Tabe Tabi <tabi.tabe at gmail.com> wrote:

> Hi,
>
> I read in one of the emails that it is possible to setup a subscriber to
> connect to SPCE with IP address authentication, instead of SIP username and
> password. I am trying to do that but realized that the subscriber account
> requires SIP username and password.
>

It is required to enter one, but it does not have to be used if you set
Trusted Source and a Permanent Registration.

>
> I have setup a subscriber with a DID and tested with a polycom phone and
> it can make outboud and receive inbound calls no problem. On the same
> account, tried using on an IP PBX which only support IP authentication SIP
> trunk without SIP username and password and it fails. It can neither
> receive nor make calls. Here is what I did:
>
> Subscriber--->Details --> Preferences --->Trusted Source . Here I added
> the IP address of the IP PBX (both are in the same LAN and Subnet)
>
>
I presume you also included the Protocol and a From Pattern such as
"^sip:.*"

If the Trusted source was set up correctly, you should have been able to at
least make outbound calls from your PBX. If not you need to provide some
logs.


> Then I enabled E164_to_RURI here:
> Subscriber--->Details --> Preferences --->Number Manipulation
>
> By making the changes above, I assume that SPCE will not expect the PBX to
> send username and password and will process the calls. Also, all calls made
> to the DID will be routed to the PBX.
>
>
The above will only make it so that SPCE does not require authentication
when the PBX makes an outbound call. To get inbound working you need also
to create a Permanent Registration for this peer - this tells SPCE where to
send calls for this subscriber without the subscriber needing to register
itself.

Go to

Subscriber---> Details --> Registered Devices -> Create Permanent
Registration

and enter in something like:

sip:username at ip_address:5060

Where username can be anything (but we would usually keep it the same as
the subscriber username) and the IP address the IP of the PBX.



> I have the PBX working fine with Gendband S3 as a reference. Am I doing
> something wrong or did I miss a step?
>
> You feedback is much appreciated.
>

Hope this helps.

-Barry


>
> Regards,
>
>
> --
> ...Tabi
>
>
> _______________________________________________
> Spce-user mailing list
> Spce-user at lists.sipwise.com
> http://lists.sipwise.com/listinfo/spce-user
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sipwise.com/pipermail/spce-user_lists.sipwise.com/attachments/20140430/6c5a4baa/attachment-0001.html>