[Spce-user] How To install mr5.0.1 at digital ocean

[Chef Syaiful Bahri Kamaruddin]

Hi Andrew,

How to ease the installation as I had notice digitalocean having 3 network lo , eth0 , eth1(private) , during installation the SW installer skip the eaddress configuration. Is there a way to avoid this. As during trial on VM on my PC, all is ok.

Regards
Syaiful

-----Original Message-----
From: Spce-user [mailto:spce-user-bounces at lists.sipwise.com] On Behalf Of Chef Syaiful Bahri Kamaruddin
Sent: Friday, December 30, 2016 6:48 PM
To: Andrew Pogrebennyk <apogrebennyk at sipwise.com>
Cc: Spce-user <Spce-user at lists.sipwise.com>
Subject: Re: [Spce-user] How To install mr5.0.1 at digital ocean

Hi Andrew,
After apply ngcpcfg , still bad gateway. But checking the ngcpcfg status all is OK

Regards

Syaiful

-----Original Message-----
From: Andrew Pogrebennyk [mailto:apogrebennyk at sipwise.com] 
Sent: Friday, December 30, 2016 6:45 PM
To: Chef Syaiful Bahri Kamaruddin <chefsyaiful at outlook.com>
Cc: Spce-user <Spce-user at lists.sipwise.com>
Subject: Re: [Spce-user] How To install mr5.0.1 at digital ocean

The web server (nginx) will not run until you apply configuration changes. Only reinstall will not help.
You should run ngcpcfg apply. This is what I wrong in my 1st email..

Regards,
Andrew

On 30/12/16 11:42, Chef Syaiful Bahri Kamaruddin wrote:
> Hi Andrew,
> Installation done at digitalocean.com  connecting ip on eth0 . ngcpcfg apply network also done. But still bad gateway.
> I think I should reinstall clean then set all parameter accordingly first..is there a way that during initial installation I see eadress autoconfig skip as multiple network..
> 
> Syaiful

_______________________________________________
Spce-user mailing list
Spce-user at lists.sipwise.com
https://lists.sipwise.com/listinfo/spce-user