[Spce-user] Sipwise CE 6.5,3 installation issues

[Manuel Montecelo]

2019-01-25 19:54 rleone.soluzioni at libero.it:
>   Hi Manuel,
>
>   after many test i found the problem: I had to set ipv4 as default protocol
>   in "/etc/gai.conf"  
>   with ipv6, for some strange reason, ping on some addresses worked indeed
>   the process of installation did not reported error about connection only
>   the command "ngcp-status".

I am glad that this problem is sorted out.

Are all of the config problems sorted out now, or only the pings?


>   One question again: if i upgrade from 5.5.7 to 6.5.3 the partitions remain
>   as they were in the previous version, correct?

Yes, upgrades from older versions should maintain the old partition scheme, only
new installations will get the separation with data in /ngcp-data/.


Cheers.
-- 
Manuel Montecelo <mmontecelo at sipwise.com>
Release Engineer

Sipwise GmbH, Campus 21/Europaring F15
AT-2345 Brunn am Gebirge

Office: +43(0)13012029 | Website: https://www.sipwise.com