[Spce-user] Sipwise CE 6.5,3 installation issues

[rleone.soluzioni at libero.it]

Hi,

all configuration files are ok.  

Thanks
 
> Il 25 gennaio 2019 alle 20.31 Manuel Montecelo <mmontecelo at sipwise.com> ha scritto:
> 
> 
> 2019-01-25 19:54 rleone.soluzioni at libero.it:
> >   Hi Manuel,
> >
> >   after many test i found the problem: I had to set ipv4 as default protocol
> >   in "/etc/gai.conf"  
> >   with ipv6, for some strange reason, ping on some addresses worked indeed
> >   the process of installation did not reported error about connection only
> >   the command "ngcp-status".
> 
> I am glad that this problem is sorted out.
> 
> Are all of the config problems sorted out now, or only the pings?
> 
> 
> >   One question again: if i upgrade from 5.5.7 to 6.5.3 the partitions remain
> >   as they were in the previous version, correct?
> 
> Yes, upgrades from older versions should maintain the old partition scheme, only
> new installations will get the separation with data in /ngcp-data/.
> 
> 
> Cheers.
> -- 
> Manuel Montecelo <mmontecelo at sipwise.com>
> Release Engineer
> 
> Sipwise GmbH, Campus 21/Europaring F15
> AT-2345 Brunn am Gebirge
> 
> Office: +43(0)13012029 | Website: https://www.sipwise.com