[Spce-user] Problem with callout

[William Fulton]

Tran,

Are you using the local sip provider as a Peer? Also, if you only have one DID from your sip provider you would likely be better of using a PBX instead.

Thanks!
Bill

From: Tran <tranjk09 at gmail.com>
Sent: Sunday, May 24, 2020 9:50 AM
To: spce-user at lists.sipwise.com
Subject: Re: [Spce-user] Problem with callout

Hi,

Any one can help, i have problem with some SIP provider, not one.

SPCE can't call out because sip message is not correct as i sent in last email

On Sat, 23 May 2020 at 09:47, Tran <tranjk09 at gmail.com<mailto:tranjk09 at gmail.com>> wrote:
Hi,

Anyone can help ?

On Fri, 22 May 2020 at 13:26, Tran <tranjk09 at gmail.com<mailto:tranjk09 at gmail.com>> wrote:
Hi,

I use SIP Wise 8.3, i config it as gateway to connect from local to SIP provider.

I can get inbound call ok, but outbound call have problem:
- PBX with IP x.x.x.x will connect as subscriber of SIPwise (IP y.y.y.y) and connect to SIP provider (using AAREswitch)
- SIP provider said that they get message from IP y.y.y.y but some thing in sip message not ok so call rejected:
+  field From is "A at x.x.x.x<mailto:A at x.x.x.x>", they expect From is A at y.y.y.y<mailto:A at y.y.y.y>
+ contact URI is: ngcp-lb at y.y.y.y<mailto:ngcp-lb at y.y.y.y> , they expect contact URI is : A at y.y.y.y<mailto:A at y.y.y.y>
(A is caller id which SiP provider sell us)

I looking around and can't see how to change, any one can help ?

Thank you


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sipwise.com/pipermail/spce-user_lists.sipwise.com/attachments/20200524/26d0cb2e/attachment-0002.html>