[Spce-user] Problem with callout

[Tran]

Hi William,

I use SIPWise to transcode and routing for multiple PBX.

If only have one PBX and connect directly to sip provider, configuration is
easy.

I still look for solution for my case.

Thank you.

On Mon, 25 May 2020 at 04:15, William Fulton <wfulton at thirdhatch.com> wrote:

> Tran,
>
>
>
> Are you using the local sip provider as a Peer? Also, if you only have one
> DID from your sip provider you would likely be better of using a PBX
> instead.
>
>
>
> Thanks!
>
> Bill
>
>
>
> *From:* Tran <tranjk09 at gmail.com>
> *Sent:* Sunday, May 24, 2020 9:50 AM
> *To:* spce-user at lists.sipwise.com
> *Subject:* Re: [Spce-user] Problem with callout
>
>
>
> Hi,
>
>
>
> Any one can help, i have problem with some SIP provider, not one.
>
>
>
> SPCE can't call out because sip message is not correct as i sent in last
> email
>
>
>
> On Sat, 23 May 2020 at 09:47, Tran <tranjk09 at gmail.com> wrote:
>
> Hi,
>
>
>
> Anyone can help ?
>
>
>
> On Fri, 22 May 2020 at 13:26, Tran <tranjk09 at gmail.com> wrote:
>
> Hi,
>
>
>
> I use SIP Wise 8.3, i config it as gateway to connect from local to SIP
> provider.
>
>
>
> I can get inbound call ok, but outbound call have problem:
>
> - PBX with IP x.x.x.x will connect as subscriber of SIPwise (IP y.y.y.y)
> and connect to SIP provider (using AAREswitch)
>
> - SIP provider said that they get message from IP y.y.y.y but some thing
> in sip message not ok so call rejected:
>
> +  field From is "A at x.x.x.x", they expect From is A at y.y.y.y
>
> + contact URI is: ngcp-lb at y.y.y.y , they expect contact URI is : A at y.y.y.y
>
> (A is caller id which SiP provider sell us)
>
>
>
> I looking around and can't see how to change, any one can help ?
>
>
>
> Thank you
>
>
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.sipwise.com/pipermail/spce-user_lists.sipwise.com/attachments/20200525/fb801b06/attachment-0002.html>