[Spce-user] How To install mr5.0.1 at digital ocean

[Chef Syaiful Bahri Kamaruddin]

Ok Andrew,
Changing swap value and performance. Hope it will ok..will update you on this. Trying this before changing to PRO or Appliance. 

Best Regards
Syaiful

-----Original Message-----
From: Andrew Pogrebennyk [mailto:apogrebennyk at sipwise.com] 
Sent: Friday, December 30, 2016 7:59 PM
To: Chef Syaiful Bahri Kamaruddin <chefsyaiful at outlook.com>; Spce-user <Spce-user at lists.sipwise.com>
Subject: Re: [Spce-user] How To install mr5.0.1 at digital ocean

On 30/12/16 12:53, Chef Syaiful Bahri Kamaruddin wrote:
> Still after initial the panel start. Still error

Probably there is not enough RAM to start panel. The minimum system requirement is 2GB RAM but even that is not enough if there is no swap.
Check if panel is running: /etc/init.d/ngcp-panel status if not you can try to lower performance:
ngcp-toggle-performance-config --low-performance && ngcpcfg apply 'low performance'
Check if it's running again. In long term you should add more RAM/swap.

Andrew