[Spce-user] How To install mr5.0.1 at digital ocean

[Chef Syaiful Bahri Kamaruddin]

Hi Andrew,
At last, get the login after

1)Do clean install of Debian and config the network interface
2) change swap value to 4Gb (need more RAM)
3) Clean install SPCE
4) Follow multi network config for network
5) make it low performance as per your advise
6) Reboot

After this stage, create domain, should I create the domain in DNS record also? As very new to this, as in the SPCE NGCP create domain, is it need to create record?

Best Regards
Syaiful

-----Original Message-----
From: Spce-user [mailto:spce-user-bounces at lists.sipwise.com] On Behalf Of Chef Syaiful Bahri Kamaruddin
Sent: Friday, December 30, 2016 8:03 PM
To: Andrew Pogrebennyk <apogrebennyk at sipwise.com>; Spce-user <Spce-user at lists.sipwise.com>
Subject: Re: [Spce-user] How To install mr5.0.1 at digital ocean

Ok Andrew,
Changing swap value and performance. Hope it will ok..will update you on this. Trying this before changing to PRO or Appliance. 

Best Regards
Syaiful

-----Original Message-----
From: Andrew Pogrebennyk [mailto:apogrebennyk at sipwise.com] 
Sent: Friday, December 30, 2016 7:59 PM
To: Chef Syaiful Bahri Kamaruddin <chefsyaiful at outlook.com>; Spce-user <Spce-user at lists.sipwise.com>
Subject: Re: [Spce-user] How To install mr5.0.1 at digital ocean

On 30/12/16 12:53, Chef Syaiful Bahri Kamaruddin wrote:
> Still after initial the panel start. Still error

Probably there is not enough RAM to start panel. The minimum system requirement is 2GB RAM but even that is not enough if there is no swap.
Check if panel is running: /etc/init.d/ngcp-panel status if not you can try to lower performance:
ngcp-toggle-performance-config --low-performance && ngcpcfg apply 'low performance'
Check if it's running again. In long term you should add more RAM/swap.

Andrew
_______________________________________________
Spce-user mailing list
Spce-user at lists.sipwise.com
https://lists.sipwise.com/listinfo/spce-user